Overcome the error message (beep sound) in the Award Bios
Automatically when the computer can not run so
lit it sounds a "beep" from the PC that does not usually. You
to find out what the problem on your computer, if not then do not expect a computer
you can use. In this article I will review some problems or error occurs
in bios you can directly computer.Please find information about it in the article
it.
But first you must know bios type used your PC. BIOS type of information
This can arise when you know the first time after you turn on your computer. Or you can also
can find out on your motherboard's manual. Is use AMI BIOS, Award BIOS, IBM
BIOS, or any other brand.
Once you know the type of BIOS, now you live
listening to the sound of "beep" which came out after you press the power button the computer
you.
AWARD BIOS
+ Beeps repeated endlessly (when PCs had just turned on)
- Meaning
there is a problem on your PC memory card (Memory RAM)
_ The solution: - Check and make sure the card
Your memory is installed perfectly.
- Remove the memory card and clear the card plate
memory with a brush and a brass section with a 2B pencil eraser and then plug it in again
perfectly.
- Try to pair your memory card on another PC.
- What if the above methods
not solve the problem, means there is damage to your memory card.
+ Beep
repeated endlessly (when the PC is in use)
- That there is a problem on the CPU temperature
too hot.
_ The solution: - Check and make sure the processor fan spin very well. If
dirty, you need to clean it up.
- If necessary, you can install an additional fan on the CPU casing
you
+ Beeps repeated high-low tones without stopping
- That there is a problem on the processor
you.
_ The solution: - Possible installation of the processor is less than perfect.
- Check and make sure
processor fan spin very well, if dirty clean with a brush.
+ 1 long beep, 2
short beeps
- There was a problem in the graphics card (VGA Card) your PC.
_ Solution: - Check and make sure
Your graphics card is installed perfectly. The position of the card is less tight or less into the slot can be
problem.
- Check and make sure the monitor cable plugs are connected to the graphics card also has
installed perfectly. Tighten the bolts on both sides.
- If you have not completed
the problem, try out the graphics card and graphics card plate clean with a brush. Clean also
graphics card slot on the motherboard with a brush or a vacuum cleaner and a brass plate on the card
graphics using 2B pencil eraser. Then plug it in again with a perfect graphics card.
--
If the above methods have also qualified for troubleshooting your VGA card, try using the card
other graphics on your motherboard.
- If your graphics card is fine, then there is a problem with
graphics card slot on your motherboard. To overcome your motherboard to take place
service make appointed by your motherboard.
+ 1 long beep, 3 short beeps
- There
problems in graphics cards (VGA Card) your PC is not detected or damaged.
_ Solution: - Check and
make sure your graphics card is installed perfectly. The position of the card is less tight or less into the slot
could be a problem.
- If you have not solved the problem, try out the graphics card and clean
plate graphics card with a brush. Clean graphics card slot is also on the motherboard with a brush or
vacuum cleaner and a brass plate on the graphics card using 2B pencil eraser. Then
plug it in again with a perfect graphics card.
- If the above methods have also qualified for
troubleshooting your VGA card, try using another graphics card on your motherboard.